For More Imformation +90 (536) 860 10 00
The application is applied on a single surface in a thin layer (if desired, in a double surface) using a spray gun with an atmosphere pressure of 4-6 bar. After application, it should be waited for a while until the solvent evaporates. This time depends on the amount of adhesive applied, indoor temperature and air flow density. The surfaces on which the adhesive is applied should be bonded within 3 minutes. Since the correction will not be possible, the assembly must be error free.
Storage 6 months at room temperature
In various Solid Contents and Viscosities
Non-flammable
Yellow/Red Colours avaliable
Hotmelt adhesives are high performance adhesives produced in 100% solid form and without solvent.
They can be easily applied in one and two ways with the automatic hotmelt machine. Application temperature should be between 150 ° C and max 190 ° C. Care should be taken to ensure that the surfaces to be applied are clean, oil-free and dry.
Water-based Glue use water instead of harmful solvents to make the glue less irritating and flammable on human skin. This glue contains large-scale water as a water-based adhesive and solvent material. Since the evaporation rate of water is slower than solvent, it causes longer drying time for the glue.Storage 6 months at room temperature
In various Solid Contents and Viscosities
Non-flammable
Yellow/Red Colours avaliable
